In Woodtech we have been making bluetooth speakers. We had the make these out of wood and a homemade circuit. Here are the steps that I took to make it.
1. Mark the holes for the nails to go in
2. Drill them out on the drill press, glue then nail the sides together
3. Paint your box
4. Glue mesh, solder the speakers to their wires and glue them in
5. Solder the resister to the short leg of the Led and otherside of the resister to the red wire of the battery pack
6. Solder an extra wire to the battery pack and the switch. The middle bit of the switch not the sides
7. Connect all the things to the chip to make sure it works (Remember batterys)
8. If it works stick the switch and the led through the holes you made and glue them in place and after glue the battery pack to the otherside of the box
9. Plug in the chip and close the box. You are basically done.
No comments:
Post a Comment
Please structure your comments as follows:
Positive - Something done well.
Thoughtful - A sentence to let us know you actually read/watched or listened to what they had to say.
Helpful - Give some ideas for next time or Ask a question you want to know more about.